Blodgett SC-G Series - Manual (Page 6)

4 OM-SC-G
Your Atmospheric Convection Steamer is designed to give years of service. It has two
stainless steel cavities (cooking chambers) which are served by twin, independent
atmospheric steam generators which are gas-heated. A powerful blower circulates the
steam in each cavity, to increase heating efficiency.
Each cavity holds up to three steam table pans (12”x 20” x 2½”). A 16 gauge stainless
steel cabinet encloses the cavities, the steam generators and the control compartment
that houses electrical components. Door hinges are reversible (the doors may be set to
open from the left or right). Operating Controls are on the front panel.
Steamers are equipped with fully electronic controls and a button-activated, pre-
programmed CLEAN cycle. These units are readily identified by a unique control panel.
The drain system includes a spray condenser, which reduces condensate temperature
and helps keep steam from escaping through the drain.
Voltage: 108-126 VAC Single Phase 50/60 Hz
Current: 2.5 AMPs ± 10%
Equipment Description
BURNER FIRING RATES
INPUT RATES, BTU/HOUR
NATURAL GAS
at 3.7” W.C.
LP GAS
at 10.5” W.C.
Individual Steam Generator 45,000 45,000
Total, Both Cavities 90,000 90,000
WARNING
BEFORE REMOVING ANY PARTITION OR
PANEL, TURN OFF THE ELECTRICAL POWER
AND LET THE FAN STOP ROTATING.
BEFORE WORKING ON ANY ELECTRICAL
COMPONENT, DISCONNECT THE POWER
SOURCE FROM THE UNIT.
WARNING
THE UNIT MUST BE INSTALLED BY
PERSONNEL WHO ARE QUALIFIED TO WORK
WITH GAS, ELECTRICITY AND PLUMBING.
IMPROPER INSTALLATION CAN CAUSE
INJURY TO PERSONNEL AND/OR DAMAGE TO
THE EQUIPMENT. THE UNIT MUST BE
INSTALLED IN ACCORDANCE WITH
APPLICABLE CODES.
The steamer has two independent cavities, each
with its own base-mounted steam generator.