Blodgett CTBR-GFB - Manual (Page 6)

4
Installation
Oven Assembly
4” CASTEr INSTALLATION
1. Lay the oven on its side.
2. Thread casters into the four mounting nuts located in
each corner on the bottom of the oven. make sure two
locking casters are installed in the front of the oven.
NOTE: Be sure the casters are screwed in tightly
and no threads are exposed.
OVEN LEVELING
After assembly, the oven should be leveled and moved
to the operating location.
1. If the casters need to be adjusted to level the oven,
unstrew the effected caster and install one 1/8” thick
washer provided in the kit. A second washer can be
installed on the same caster if more adjustment is re-
quired.
2. Reinstall the caster, making sure the caster is in-
stalled tight and not threads are exposed.
Figure 1
ADjUSTMENTS ASSOCIATED wITh INITIAL INSTAL-
LATION
Each oven, and its component parts, have been thor-
oughly tested and inspected prior to shipment. However, it
is often necessary to further test or adjust the oven as part
of a normal and proper installation. These adjustments
are the responsibility of the installer, or dealer. Since
these adjustments are not considered defects in mate-
rial or workmanship, they are not covered by the Original
Equipment Warranty. They include, but are not limited to:
• calibration of the thermostat
• adjustment of the doors
• leveling
• tightening of fasteners.
No installation should be considered complete without
proper inspection, and if necessary, adjustment by quali-
fied installation or service personnel.