Allied Telesis AT-S21 - Manual (Page 18)

&RQQHFWLQJ#D#7HUPLQDO#DQG#6WDUWLQJ#D#/RFDO#6HVVLRQ
2-2
&RQQHFWLQJ#D#7HUPLQDO#DQG#6WDUWLQJ#D#/RFDO#6HVVLRQ
This procedure applies if:
❑ You are managing the switch locally.
❑ You are managing the switch in a TCP/IP environment and you
are configuring IP parameters for the first time.
1. Connect a terminal or PC directly to the switch’s RS232 port and
configure the terminal or emulation program as follows:
VT100 emulation
8 data bits
1 stop bit
No parity
9600 bps
2. Press .
The main Omega menu displays.
Figure 2-1 Main Menu
As a default, the software does not require a password for access. You
may later configure a password (described in Chapter 3 in the
section, System Configuration on page 3-10). The switch is now
operational at the default settings listed in Table 2-1.
Allied Telesyn AT-8124XL Ethernet Switch: 1.0
Main Menu
Port status and configuration
Ethernet statistics
Administration
System configuration
Virtual LANs
Bridging
MAC Address Table
Quit