Ensure that the package includes the required i, Remove all equipment from the packing box and s, Insert the female end of the power cord into th – Allied Telesis AT-MR912TX User Manual

Page 37: Insert the male end of the power cord into an e, Check the front panel of the hub to make sure t, Plug all category 5 stp/utp cables into the 100, Figure12: standalone at-mr912tx front panel, Plug the opposite end of each 100base-tx cable

AT-MR912TX Installation Manual

Installation procedures are as follows:

1. Ensure that the package includes the required items presented in Chapter

2. Remove all equipment from the packing box and store the box and packing

materials in a safe place. Your hub may need to be transferred in the
future.

3. Insert the female end of the power cord into the Power Receptacle on the

back of the unit.

4. Insert the male end of the power cord into an electrical output of the

appropriate power.

5. Check the front panel of the hub to make sure the green power (PWR) LED

is illuminated.

6. Plug all Category 5 STP/UTP cables into the 100Base-TX network ports

(RJ-45 connectors) on the front of the unit.

Figure 12: Standalone AT-MR912TX Front Panel

7. Plug the opposite end of each 100Base-TX cable into a network node or

workstation.

Note

The Collision Domain Diameter (total allowable distance end-to-end)
for a Class I repeater cannot exceed 200 meters. That is, the hub-to-
device connection should never be more than 100 meters in length.

You are now ready to operate your AT-MR912TX hub in a standalone, Class I,
network configuration.

100Base-TX Ports

Power LED