Allied Telesis AT-S63 - Manual (Page 845)

AT-S63 Management Software Menus Interface User’s Guide
Section IX: Management Security 845
Configuring the RADIUS Client
To configure the RADIUS client, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 60.
2. From the System Administration menu, type 6 to select Authentication
Configuration.
The Authentication Configuration menu is shown in Figure 278 on
page 840.
3. Type 4 to select RADIUS Configuration.
The RADIUS Client Configuration menu is shown in Figure 281.
Figure 281. RADIUS Client Configuration
4. Adjust the following parameters as necessary.
Global Encryption Key
This parameter specifies the encryption key for the RADIUS servers.
This option is useful if you will be entering more than one RADIUS
server and all the servers share the same encryption key. The
maximum length is 39 characters. The default is ATI.
Global Server Timeout period
This parameter specifies the maximum amount of time the switch waits
for a response from a RADIUS server before assuming that the server
does not respond. If the timeout expires and the server has not
responded, the switch queries the next RADIUS server in the list. If
there are no more servers, then the switch defaults to the standard
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
RADIUS Client Configuration
1 - Global Encryption Key ............. ATI
2 - Global Server Timeout period....... 10 second(s)
3 - RADIUS Server 1 Configuration ..... 0.0.0.0
4 - RADIUS Server 2 Configuration ..... 0.0.0.0
5 - RADIUS Server 3 Configuration ..... 0.0.0.0
6 - Show Status
R - Return to Previous Menu
Enter your selection?