Allied Telesis AT-S63 - Manual (Page 697)

Section VII: Internet Protocol Routing 697
Chapter 29
Internet Protocol Version 4 Routing
Interfaces
This chapter contains the following procedures for managing Internet
Protocol Version 4 (IPv4) routing interfaces:
ˆ “Creating a New Routing Interface” on page 698
ˆ “Modifying a Routing Interface” on page 701
ˆ “Deleting a Routing Interface” on page 704
ˆ “Displaying the IP Address of the Local Interface” on page 705
ˆ “Setting the Default Route or Default Gateway” on page 707
ˆ “Setting the Local Interface” on page 708
ˆ “Setting the ARP Cache Timeout” on page 709
Note
The IPv4 packet routing feature consists of three components —
routing interfaces, static routes, and the Router Information Protocol
(RIP). The menus interface supports just routing interfaces. Refer to
Chapter 32, “Internet Protocol Version 4 Packet Routing,” in the
AT-S63 Management Software Command Line Interface User’s
Guide for an overview of the IPv4 routing feature and the commands
for managing all of the routing elements.