Allied Telesis AT-S63 - Manual (Page 438)

Chapter 21: SNMPv3
438 Section IV: SNMPv3
This is an optional parameter that is used to further refine the value in
the View Subtree parameter. This parameter is in binary format.
A subtree mask and a subtree have a similar relationship as an IP
address and a subnet mask. The subnet mask further refines the IP
address. In the same way, the OID table entry defines a MIB View and
the subtree mask further restricts a user’s view to a specific the
column and row of the MIB View. The value of the Subnet Mask
parameter is dependent on the subtree you select. For example, if you
configure the View Subtree parameter as MIB, ifEntry.0.3 has the
following value:
1.3.6.1.2.1.2.2.1.0.3
To restrict the user’s view to the third row (all columns) of the ifEntry
MIB, enter the following value for the Subtree Mask parameter:
ff:bf
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying a View Type
To modify the View Type parameter in an SNMPv3 View Table entry,
perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 422. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 140 on page
423.
2. From the Configure SNMPv3 Table menu, type 3 to select Configure
SNMPv3 View Table.
The Configure SNMPv3 View Table menu is shown in Figure 143 on
page 433.
3. From the Configure SNMPv3 View Table menu, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Table menu is shown in Figure 144 on page 437.
4. To modify the View Type, type 2 to select Set View Type.
The following prompt is displayed:
Enter View Name:
5. Enter a View Name that was previously configured.