Allied Telesis AT-S63 User Manual
Page 121

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations
121
Note
The speed, duplex mode, and flow control settings are blank for a
port that has not established a link to its end node.
The Port Status menu displays a table that contains the following
columns of information:
Port
The port number.
Link
The status of the link between the port and the end node connected to
the port. The possible settings are:
Up - Indicates that a valid link exists between the port and the end
node.
Down - Indicates that the port and the end node have not established a
valid link.
Neg
The status of Auto-Negotiation on the port. Possible values are:
Auto - Indicates that the port is using Auto-Negotiation to set operating
speed and duplex mode.
Manual - Indicates that the operating speed and duplex mode have
been set manually.
MDIO
The operating configuration of the port. Possible values are Auto, MDI,
MDI-X. The status Auto indicates that the port automatically
determines the appropriate MDI or MDI-X setting.
Speed
The operating speed of the port. Possible values are:
10 - 10 Mbps
100 - 100 Mbps
1000 - 1000 Mbps
Duplex
The duplex mode of the port. Possible values are half-duplex and full-
duplex.
PVID
The VLAN identifier (VID) of the VLAN where the port is an untagged
member. This column does not include the VIDs of the VLANs where
the port is a tagged member.