Allied Telesis AT-CM70S - Manual (Page 76)

Chapter 2: Installation
76
Cabling an SFP
Transceiver
To connect a fiber optic cable to an SFP transceiver, perform the following
procedure:
Warning
Class 1 laser product.
1
Warning
Do not stare into the laser beam.
2
1. Insert the SFP transceiver into the SFP slot on the line card, as shown
in Figure 32.
Figure 32. Inserting an SFP Transceiver into the SFP Slot
Note
For information about the proper cable type, refer to the SFP
transceiver installation instructions.
Note
Before you install the cable in the SFP transceiver, verify that the
optical power input to the transceiver is within its dynamic range.
2. Remove the dust cover from the SFP transceiver in the line card, as
shown in Figure 33.
Figure 33. Removing the Dust Cover from the SFP Transceiver
LK AT
FD
S
F
P
T
X
534
LK A T FD
S
F
P
T
X
535