Allied Telesis AT-S63 - Manual (Page 437)

AT-S63 Stack Command Line User’s Guide
Section VIII: Port Security 437
SET RADIUSACCOUNTING
Syntax
set radiusaccounting [status=enabled|disabled]
[serverport=
value ] [type=network]
[trigger=start_stop|stop_only]
[updateenable=enabled|disabled] [interval=
value ]
Parameters
status Activates and deactivates RADIUS accounting on the
switch. The options are:
enabled Activates RADIUS accounting. This
option is equivalent to “ENABLE
RADIUSACCOUNTING” on page 425.
disabled Deactivates the feature. This is the
default. This option is equivalent to
“DISABLE RADIUSACCOUNTING” on
page 423.
serverport Specifies the UDP port for RADIUS accounting. The
default is port 1813.
type Specifies the type of RADIUS accounting. The default
is Network. This value cannot be changed.
trigger Specifies the action that causes the switch to send
accounting information to the RADIUS server. The
options are:
start_stop The switch sends accounting information
whenever a client logs on or logs off the
network. This is the default.
stop_only The switch sends accounting information
only when a client logs off.
updateenable Specifies whether the switch is to send interim
accounting updates to the RADIUS server. The
default is disabled. If you enable this feature, use the
INTERVAL parameter to specify the intervals at which
the switch is to send the accounting updates.
interval Specifies the intervals at which the switch is to send
interim accounting updates to the RADIUS server.
The range is 30 to 300 seconds. The default is 60
seconds.