Allied Telesis AT-S63 - Manual (Page 180)

Chapter 11: LACP Port Trunking Commands
180 Section I: Basic Operations
DELETE LACP PORT
Syntax
delete lacp aggregator= name port= port
Parameters
aggregator Specifies the name of the aggregator. The name is
case-sensitive.
port Specifies the port(s) to be removed from the
aggregator. Port numbers are specified in the following
format:
module ID.port number
For instructions, refer to “Port Numbers in Commands”
on page 42.
Description
This command removes a port from an aggregator. You must identify the
aggregator by its name. To display the names of the aggregators on the
switch, refer to “SHOW LACP” on page 188. To completely remove an
aggregator, see “DESTROY LACP AGGREGATOR” on page 181.
Caution
Disconnect the network cable from a port before removing the port
from an aggregator. Removing a port without first disconnecting the
cable might form loops in your network topology, which can cause
broadcast storms and poor network performance.
Note
You cannot delete the lowest numbered port from an aggregator,
also referred to as the base port. For example, if an aggregator
consists of ports 7 to 12, you cannot delete port 7. You must delete
and recreate an aggregator to remove the base port.
Example
This command removes port 2.9 from the “lacp_server” aggregator:
delete lacp aggregator=lacp_server port=2.9