Allied Telesis AT-S63 - Manual (Page 399)

AT-S63 Stack Command Line User’s Guide
Section VII: Internet Protocol Routing 399
PURGE IP
Syntax
purge ip
Parameters
None.
Description
This command deletes all routing interfaces on the stack. Note the
following before performing this command:
ˆ All IPv4 packet routing on the stack ceases. The device, however,
continues to switch packets among the ports within the VLANs (but not
across the VLAN boundaries) using Layer 2.
ˆ All static routes are deleted from the route table.
ˆ The AT-S63 Management Software stops performing those
management functions that require access to a network management
device (e.g., a RADIUS server).
ˆ Deleting all interfaces deletes the local interface. This prohibits you
from remotely managing the device with a Telnet or SSH client, or with
a web browser.
ˆ Deleting all interfaces during a remote Telnet or web browser
management session immediately ends your session. To continue
managing the stack, you must start a local management session using
the Terminal Port on the master switch.
Example
This command deletes all routing interfaces on the stack:
purge ip interface