Allied Telesis AT-S63 - Manual (Page 188)

Chapter 11: LACP Port Trunking Commands
188 Section I: Basic Operations
SHOW LACP
Syntax
show lacp [port= port ] [aggregator] [machine= port ]
Parameter
port Specifies the port(s) to display. Port numbers are
specified in the following format:
module ID.port number
For instructions, refer to “Port Numbers in Commands”
on page 42.
aggregator Displays information about the aggregators.
machine Specifies the LACP machine state for a port or ports on
the system.
Description
This command displays the configuration and/or machine states of the
ports, and/or the aggregators. Entering the command without any
parameters displays general LACP status information. Figure 20
illustrates the information displayed by this command.
Figure 20. SHOW LACP Command
The command displayed the following information:
ˆ Status - Whether the LACP protocol is enabled or disabled on the
switch.
ˆ MAC Address - The MAC address of the switch.
ˆ Priority - The LACP system priority value assigned to the switch.
Status ...........................: Enable
Mac Address .......................: 00-21-46-A7-B4-43
Priority ........................: 0x0080
Collector delay ..................: 0 Seconds