Allied Telesis AT-S63 - Manual (Page 259)

AT-S63 Stack Command Line User’s Guide
Section II: Advanced Operations 259
SHOW LOG OUTPUT
Syntax
show log output[= output-id ] [full]
Parameters
output Specifies the output definition ID number. If an output
ID number is not specified, all output definitions on
the stack are displayed.
full Displays the details of the output definition. If not
specified, only a summary is displayed.
Description
This command displays output definition details. An example of the
information displayed by this command is shown in Figure 28.
Figure 28. SHOW LOG OUTPUT Command
The columns in the display are described below:
ˆ Output ID - The ID number of the output definition. The permanent
event log has the ID 0 and the temporary log has the ID 1. Syslog
server definitions start with ID 2.
ˆ Type - The type of output definition. Permanent is the permanent event
log and Temporary is the temporary event log. Syslog indicates a
syslog server definition.
ˆ Status - The status of the output definition, which can be enabled or
disabled.
ˆ Details - The event log full action or a syslog server’s IP address. For
an event log, this column contains the log’s full action. Wrap on Full
indicates that the log adds new entries by deleting old entries when it
reaches maximum capacity. Halt on Full means the log stops adding
entries after reaching maximum capacity. To configure the full action
for an event log, refer to “SET LOG FULLACTION” on page 250. For a
syslog definition, this column contains the IP address of the syslog
server.
OutputID Type Status Details
-----------------------------------------------------------
0
Permanent Enabled Wrap on Full
1 Temporary Enabled Wrap on Full
2 Syslog Enabled 169.55.55.55
3 Syslog Enabled 149.88.88.88