Allied Telesis AT-S63 - Manual (Page 385)

AT-S63 Stack Command Line User’s Guide
Section VI: Virtual LANs 385
SHOW VLAN
Syntax
show vlan[= name | vid ]
Parameter
vlan Specifies the name or VID of the VLAN.
Description
This command displays the VLANs on the stack. An example of the
information displayed by this command for port-based and tagged VLANs
is shown in Figure 40.
Figure 40. SHOW VLAN Command for Port-based and Tagged VLANs
The information displayed by the command is described here:
ˆ VLAN name - The name of the VLAN.
ˆ VLAN ID - The ID number assigned to the VLAN.
ˆ VLAN Type - The type of VLAN. This will be Port Based for port-based
and tagged VLANs.
ˆ Protected Ports - The status of protected ports. Since port-based and
tagged VLANs are not protected ports VLANs, this will be No.
ˆ Untagged port(s) - The untagged ports of the VLAN. The untagged
ports are listed as follows.
– Configured: The untagged ports of the VLAN.
VLAN Name ............................ Sales
VLAN ID .............................. 4
VLAN Type ............................ Port Based
Protected Ports ...................... No
Untagged Port(s)
Configured ......................... 1.2,2.8-2.12
Actual ............................. 1.2,2.8-2.12
Tagged Port(s) ....................... 2.24
VLAN Name ............................ Engineering
VLAN ID .............................. 5
VLAN Type ............................ Port Based
Protected Ports ...................... No
Untagged Port(s)
Configured ......................... 4.5-4.7
Actual ............................. 4.5-4.
Tagged Port(s) ....................... 2.24