Allied Telesis AT-S63 - Manual (Page 277)

AT-S63 Stack Command Line User’s Guide
Section III: Snooping Protocol 277
SHOW IP IGMP
Syntax
show ip igmp [hostlist] [routerlist]
Parameters
hostlist Displays a list of the multicast groups the stack
has learned, and the stack ports that are
connected to host nodes. For this parameter to
display information there have to be active host
nodes.
routerlist Displays the ports on the stack where multicast
routers are detected. This parameter displays
information only when there are active multicast
routers.
Description
This command displays the settings of the IGMP parameters. Figure 32
illustrates the information when the command is entered without the
optional parameters.
Figure 32. SHOW IP IGMP Command
For an explanation of these parameters, refer to “SET IP IGMP” on
page 272.
An example of the information displayed by the HOSTLIST parameter is
shown in Figure 33.
IGMP Snooping Configuration:
IGMP Snooping Status ............... Disabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum IGMP Multicast Groups ...... 64
Router Port(s) ..................... Auto Detect