beautypg.com

Powering on a switch, Figure 18: connecting the ac power cord – Allied Telesis AT-GS950/8POE User Manual

Page 53

background image

AT-GS950/8POE Gigabit Ethernet WebSmart Switch Installation Guide

53

Powering on a Switch

To power on a switch, perform the following procedure:

1. Plug the power cord into the AC power connector on the back panel of

the unit, as shown in Figure 18.

Figure 18. Connecting the AC Power Cord

2. Plug the other end of the power cord into a wall outlet.

3. Verify that the POWER LED is green. If the LED is OFF, see “Power

LED is Off” on page 56.

The switch is now powered on and ready for network operations. For
information about how to manage the switch, see the AT-S101
Management Software User’s Guide
.

Warning: Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.

E3

Pluggable Equipment. The socket outlet shall be installed near
the equipment and shall be easily accessible.

E5

741