Allied Telesis AT-GS950/8POE - Manual (Page 41)

AT-GS950/8POE Gigabit Ethernet WebSmart Switch Installation Guide
41
Installing the Switch on a Wall
To install the switch on a wall, perform the following procedure:
Note
Steps 1, 2, and 3 are optional. These steps provide instructions on
how to remove the snap-on plastic feet from the bottom of a switch.
You can leave the feet attached to the switch.
1. Place the switch upside down on a level, secure surface.
2. Using a flat-head screwdriver, remove the snap-on plastic feet from the
bottom of the switch, as shown in Figure 7 on page 39.
3. Turn the switch over.
4. Attach the two rack-mounting brackets (provided) to the sides of the
switch using the eight flathead Phillips screws (provided), as shown in
Figure 10.
Figure 10. Attaching a Rack-mount Bracket for Wall mounting
1354
AT-GS950/8POE
8 P ort 10/100/
1000Mbps + 2
SFP Combo
WebSma
rt Switch
SFP
SFP
CLAS S 1 LAS ER P RODUC T
1 2 3 4 5 6 7R
7 8
8R
POWER RESET
1
2
3
4
5
6
7R
8R
7
8
POE
100 /100 0Ba se-X
POR T AC TIV ITY
ACT 100 0 L INK
100 LI NK
ACT ACT SFP