Allied Telesis AlliedView-EMS 4.0.1 VLAN MANAGER - Manual (Page 55)

Manager supports the AT-9400 series via SNMP, the 19-character limit will apply
to all operations involving VLAN Name.
• AT-9400 L3 Models: Changing the VLAN Mode parameter setting from 'Multiple
VLAN' or '802.1Q Multiple VLAN' to 'User Configured VLAN' may result in
unpredictable behavior.
• Using an SNMPv3 account, adding a VLAN using a name that has been excluded
from the user account's view will result in an error message and the VLAN will
not be added.
• Changing the VLAN Mode parameter setting using the currently set VLAN Mode
will result in the error message: "Error: Commit Failed."
• Changing the VLAN Mode parameter setting from '802.1Q Multiple VLAN' to a
different mode may result in the error message: "Unable to communicate. Confirm
SNMP settings or login, and if the network is functional." However, VLAN Mode
is still set to the new mode successfully. To prevent this error message from
reappearing, go to File > Properties and increase the Retry Timeout value.
• The current firmware version does not allow VLAN Manager to retrieve the device
VLAN information using an SNMPv3 account with no view access in any of the
following mib object: VLAN Name, Tagged/Untagged Ports, and Status.
• An SNMPv3 account with "No Write" access will still allow users to configure the
Update VLAN Mode operation.
• Using an SNMPv3 account with "No Write" access, attempting to perform a Restart
and Import VLAN operation will result in an error message: "An error occurred
during the operation. No Access."
• After initiating a Restart operation, VLAN Manager will continuously attempt
to connect to the device for up to 1 minute until a connection is established.
• If a minute has elapsed and connection has still not been established, an error
message will be displayed.
6 Device Support
AlliedView™-EMS 4.0.1 VLAN MANAGER USER’S GUIDE Page 55 of 72