Allied Telesis AT-MC605 User Manual
Page 32
Overview
32
Selecting a Site for the AT-MC605 Ethernet Extender
Observe the following requirements when choosing a site for your
AT-MC605 VDSL Ethernet Extender:
If you plan to install a AT-MC605 Ethernet Extender into an AT-
MCR12 rackmount chassis and equipment rack, check to be sure that
the rack is safely secured and that it will not tip over. Devices in a rack
should be installed starting at the bottom, with the heavier devices
near the bottom of the rack.
The AT-MC605 Ethernet Extender may be wall mounted either on a
DINRAIL using a DINRAIL bracket or using an AT-WLMT bracket.
Both brackets are provide separately. Select a place on the wall that
provides the best cabling and power access.
Note
Both the DINRAIL bracket and the AT-WLMT wall mount bracket are
sold separately. Contact your Allied Telesis Sales representative to
purchase these items.
If you are installing the AT-MC605 Ethernet Extender on a table, be
sure that the table is level and secure.
The power outlet for the AT-MC605 Ethernet Extender should be
located near the unit and should be easily accessible.
The site should provide for easy access to the ports on the front of the
AT-MC605 Ethernet Extender. This makes it easy for you to connect
and disconnect cables, as well as view the LEDs.
To allow proper cooling of the AT-MC605 Ethernet Extender, air flow
around the unit and through its vents on the side should not be
restricted.
Do not place objects on top of the AT-MC605 Ethernet Extender.
Do not expose the AT-MC605 Ethernet Extender to moisture or water.
Make sure that the site is a dust-free environment.
You should use dedicated power circuits or power conditioners to
supply reliable electrical power to the AT-MC605 Ethernet Extender.