Driver messages – Allied Telesis AT-2912T User Manual
Page 89
Secure Ethernet Network Adapters Installation and User’s Guide
89
Driver Messages
The following messages are the most common sample messages that are
logged in the /var/log/messages file. Use the dmesg -n
command to control the level at which messages appear on the console.
Most systems are set to level 6 by default. To see all messages, set the
level higher than 6.
Driver Signon
tg3.c:v3.92n (September 29, 2008)
NIC Detected
eth0: Tigon3 [partno(BCM95704A6) rev 2003 PHY(5704)
(PCIX:100MHz:64-bit)
10/100/1000BaseT Ethernet 00:10:18:04:3f:36
eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0]
Wirespeed[1] TSOcap[1]
eth0: dma_rwctrl[769f4000] dma_mask[64-bit]
Link Up and Speed Indication
tg3: eth0: Link is up at 1000 Mbps, full duplex.
tg3: eth0: Flow control is on for TX and on for RX.
Link Down Indication
tg3: eth#: Link is down.