Allied Telesis AT-2912T - Manual (Page 76)

Chapter 5: Setting Advanced Properties
76
 For Windows 7 Operating systems, see “Selecting the Advanced
Tab in Windows 7” on page 61.
 For Windows Vista Operating systems, see “Selecting the
Advanced Tab in Windows Vista” on page 63.
The Advanced tab is shown in Figure 30 on page 60.
2. From the Property list on the Advanced tab, select Receive Side
Scaling.
3. From the Value list on the Advanced tab, select one of the following:
 Enabled
 Disabled
4. Click OK.
5. If prompted to restart your computer, click Yes.
Although it is not necessary to reboot the system for new adapter
properties to take effect, rebooting is recommended to reinitialize all
registers.
6. Verify that the port LED operates correctly. See one of the following
descriptions:
 “AT-2712FX/SC and AT-2712LX20/SC Adapters Physical
Descriptions” on page 17
 “AT-2912T Adapter Physical Description” on page 18
Updating the
Speed & Duplex
Mode Property
The Speed & Duplex Mode property allows you to set the speed of the
copper adapters as well as the change the duplex mode from full to half.
By default, the duplex mode is set to a speed of 1000 Mb in full duplex
mode.
To change the speed and duplex mode of a copper-based adapter, do the
following:
1. Access the Advanced tab:
 For Windows Server 2003 Operating systems, see “Selecting the
Advanced Tab in Windows Server 2003 or Windows XP” on
page 58.
 For Windows 7 Operating systems, see “Selecting the Advanced
Tab in Windows 7” on page 61.