Allied Telesis AT-x230-18GP - Manual (Page 52)

Chapter 2: Installation
42
Installing an AT-x230-10GP switch in an equipment rack
These instructions show you how to install an AT-x230-10GP switch in an
equipment rack. Rack mount kits for the AT-x230-10GP switch, AT-
RKMT-J14, can be purchased separately from your Allied Telesis dealer.
To install an AT-x230-10GP switch in a 19-inch equipment rack, follow
these steps:
1. If rubber feet are attached to the base of the switch, place the unit
upside down on a level, secure surface.
2. Remove the rubber feet with a screwdriver (Figure 15).
F IGURE 15. R EMOVING THE RUBBER FEET FROM A SWITCH
x230-10GP
CONSOLE
RS-232
SD
FAUL T
POWER
SD
1000 LINK ACT 10/100 LINK ACT PD ON PD ERR MAX CURRENT
SFP
9
10
2 4 6 8
1 3 5 7
MAC A ddress Label
3. Turn the switch back over.