Longhand programming mode, 4 longhand programming mode – Avaya 5610 User Manual
Page 50

4610/5610 Phone
Page 50
15-601124 Issue 05a (16 July 2009)
IP Office
7.4 Longhand Programming Mode
1.
Press
Admin or
Admin 1.
2.
To switch to longhand programming mode, press Expl?
.
3.
Press Next
until the function required is shown, then press Selct
.
4.
If the function requires some data to be entered, [ ] is shown at the bottom of the display. Enter the data using the
normal phone keypad.
5.
The upper part of the display reverts to showing the functions currently assigned to each
and
.
6.
To move between the pages of display keys, press
and
.
7.
To select the display key against which to program the new function, press
or
.
Caution
·
Do not select the slot used for the Admin function. Replacing this function will lock the phone for further
programming until reset through the phone system.
8.
If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
·
To end programming, press
PHONE/EXIT.
·
To continue programming other functions, press
Cont
9.
If the display slot already has a programmed function, the display shows FEATURE ON BUTTON. Press
or
until Repla, Keep and Delet are shown along the right-hand edge of the display.
·
To replace that existing function with the one just programmed, press Repla
. BUTTON PROGRAMMED! is
displayed.
·
To keep the existing function and forget the function just programmed, press Keep
.
·
To delete the existing function and forget the function just programmed, press Delete
.