Samsung SCH-I100ZKAUSC - Manual (Page 135)

Health and Safety Information 131
In the above example, if a hearing aid meets the M2 level rating
and the wireless mobile device meets the M3 level rating, the
sum of the two values equal M5. This is synonymous for T
ratings. This should provide the hearing aid user with “normal
usage” while using their hearing aid with the particular wireless
mobile device.
“Normal usage” in this context is defined as a signal quality that
is acceptable for normal operation. The M mark is intended to be
synonymous with the U mark. The T mark is intended to be
synonymous with the UT mark. The M and T marks are
recommended by the Alliance for Telecommunications Industries
Solutions (ATIS). The U and UT marks are referenced in Section
20.19 of the FCC Rules.
The HAC rating and measurement procedure are described in the
American National Standards Institute (ANSI) C63.19 standard.
HAC/Wi-Fi for Newer Technologies
This phone has been tested and rated for use with hearing aids for
some of the wireless technologies that it uses. However, there may
be some newer wireless technologies used in this phone that have
not been tested yet for use with hearing aids. It is important to try
the different features of this phone thoroughly and in different
locations, using your hearing aid or cochlear implant, to determine
if you hear any interfering noise. Consult your service provider or
the manufacturer of this phone for information on hearing aid
compatibility. If you have questions about return or exchange
policies, consult your service provider or phone retailer.
Restricting Children's Access to Your
Mobile Device
Your mobile device is not a toy. Do not allow children to play with
it because they could hurt themselves and others, damage the
mobile device, or make calls that increase your mobile device
bill.
Keep the mobile device and all its parts and accessories out of
the reach of small children.
M3 + M2 = 5 T3 + T2 = 5