Maximum Wireless Mystic - Manual (Page 6)

NOTE: After any "FULL" reset, temperature and/or wind chill data will be displayed and
stored after ten seconds. Pressure data will be displayed and stored after two minutes.
However, Rate of Change/Pressure will show "HOLD" for 72 minutes following a
"FULL" reset.
Any Individual function's memory can be independently reset. Move
the toggle switch to the right (auto) until that particular function is displayed.
Then move the toggle switch to the left (reset) and hold it for six seconds.
The display will quickly blank, indicating that the memory for that function
has been reset.
A "FULL" reset may also be done to clear all the memories simultaneously
or if an adjustment to the barometer setting is needed. Toggle through Mystic’s
settings until either the Present/Temperature or Present/Barometer function is displayed. Then move the toggle
switch to the left (reset) and hold it for six seconds. All the memories will reset, the display will quickly blank and
then enter into the barometer adjustment mode. If necessary the barometer may be reset at this time by adjusting
the set screw on the backplate. Exit the barometer adjustment mode by moving the toggle switch to the right
(auto) and releasing it.
When the toggle switch is in the center position Mystic will display the
information that is indicated by the function light. Data for all the other
functions is being recorded and stored.
If Mystic is Auto sequencing and you wish to turn that function off - move the
toggle switch to the right (auto) and release it. You can now manually
step through the functions as previously mentioned.
MYSTIC
OPERATION
WIRELESS
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
Page 6
Move the toggle switch at the bottom of the case to the right (auto) and allow it
to return. This manually moves the Mystic through the individual functions. The
illuminated function LED’s indicate which function and setting is being displayed.
Moving the toggle switch to the right (auto) and holding it for at least three
seconds will put Mystic into its Auto sequencing mode. You will see each
function light stay on and that particular information displayed for approximately
four seconds and then move to the next function automatically.