Maximum Wall Mount - 4" - Manual

4” WALL MOUNT
INSTALLATION
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Page 1
PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR,
ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY,
OR HARDWARE STORE FOR REFERRALS).
Slip the swaged end of mast A into the
round end of mast B.
1
2
WOOD BLOCK
SWAGED END
Tap the two sections together with a hammer.
A piece of wood will protect the end from
damage.
MAST B
SWAGED
END
MAST A
MAST B
MAST A
CLAMPING
SCREWS
Select a location that will provide the highest,
unobstructed position for the wind sensors.
3
MAST
HAMMER
TAPE MEASURE
3/8”
3/8” WRENCH
TOOLS
REQUIRED
DRILL WITH
1/8” DRILL BIT
LEVEL
BRACKET WILL
ACCOMMODATE
UP TO 4 INCH
OVERHANG OF EAVE
4 INCH WALL
BRACKET
ROOF
PEAK
PHILLIPS SCREW
DRIVER
SLOTTED SCREW
DRIVER