Maximum Wireless Mystic - Manual (Page 2)

MYSTIC
INSTALLATION
WIRELESS
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
Page 2
TEST
BUTTON
TEST LIGHT
IN
A L K
L
E
A
A L
A L IN
K
E
6
4
Once the barometer has been calibrated, toggle to a Present/Temperature
display. Within a few seconds a default temperature reading of 32.0 will
appear in the display window. Refer to the troubleshooting section if 32.0
does not appear.
5
ALKALINE
ALKALINE
BATTERIES
WIRELESS
TRANSMITTER
TEST LIGHT
L A I E A K LN Open the battery compartment of the temperature transmitter
by removing the stainless steel screws in the cover. Insert
two Alkaline batteries. The test light in the wireless transmitter
will blink red once to indicate that the batteries have been
installed properly.
TRANSMITTER
Test the transmitter by depressing the test button. After a few seconds
the test light should blink every four seconds. This indicates that the
transmitter is in test mode, which lasts for 15 minutes. At the end of
15 minutes the transmitter will return to normal operating mode. After
initial power up, the indicator light on the receiver should blink GREEN
every four seconds. This indicates proper communication between the
receiver and the temperature transmitter.
(NOTE: If more than 15 minutes has passed since the button on the
temperature transmitter was pushed, it will need to be pushed again.)
The light on the receiver will blink other colors when different sensors
are installed.
GREEN
RECEIVER
INDICATOR
ORANGE
RED
GREEN
TRANSMITTER
RED
GREEN
ORANGE
....................WIND
................RAIN
.........TEMPERATURE
2 1
OUT GND IN
5 4 3
RECEIVER
12 VOLT
POWER SUPPLY