Maximum Mystic (pre-2001) User Manual

Mystic, Installation

MYSTIC

INSTALLATION

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE,

CONSULT A CONTRACTOR, ELECTRICIAN

OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE

FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INSTALLATION.

Samuel Barnett Boulevard

New Bedford, MA 02745

(508) 995-2200

Connect the AC adapter to Mystic and plug into outlet. The display will
briefly light up all the indicator lights (self test) and then will show the
barometer function light and the center display will show a pressure
reading. Leave the instrument in this mode for two hours. Do not
activate the switch at the bottom of the case in any way. At the end
of the two hour wait Mystic will be ready to have the pressure adjustment
performed. The temperature sensor can be installed during this wait.

Form a drip loop with the wire at least eight inches
below the exit from the sensor and at least eight inches
below the point of entry into the building. Anchor any
exposed wire with insulated cable clips. Run the wire
through the building to the location where the indicator
will be located. Caulk any holes when done.

Unplug the AC adaptor and disconnect the wires. Mystic is now ready for the final installation.
The adjustment that you have made will always remain intact.

If two hours has elapsed since Mystic was plugged in, the barometer can
now be calibrated for your location. Obtain the current barometric pressure
for your area by calling a near-by airport or an individual who has a properly set
barometer. Insert a small screw driver into the recessed slotted screw at the back
of Mystic. Turn the screw while observing the pressure read out on the front of
Mystic. Due to the sensitivity of this adjustment, the numbers on the display
may fluctuate during this procedure. It may take a minute to achieve the exact
setting.

Mount the temperature sensor assembly with the two
large wood screws. Select a location that is protected
from direct sunlight and sheltered from rain and physical
damage. (A north exposure, six feet above the ground
will give the best results.)

DRIP

LOOP

CAULK

CABLE

CLIP

MIN