Maximum Eave Mount - Manual

ADJUSTABLE EAVE MOUNT
INSTALLATION
30 Barnett Boulevard
New Bedford, MA 02745
(508) 995-2200
Page 1
PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR,
ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY,
OR HARDWARE STORE FOR REFERRALS).
Slip the swaged end of mast A into the
round end of mast B.
1
WOOD BLOCK
SWAGED END
Tap the two sections together with a hammer.
A piece of wood will protect the end from
damage.
MAST A
MAST B
2”
HAMMER
TAPE MEASURE
2” WRENCH
TOOLS
REQUIRED
DRILL WITH
1/8” DRILL BIT
LEVEL
SLOTTED SCREW
DRIVER LAG
SCREW
LAG
SCREW
LAG
SCREW
UPPER
BRACKET
CARRIAGE
BOLTS
MAST
ROOF
PEAK
4
Select a location that will be high on an eave and
clear from any obstructions to air flow for the
sensors.
3
2
MAST A
MAST B
1/
1/
2 LOWER
BRACKET
1/
2 LOWER
BRACKET
1/
ROOF
PEAK LEVEL
TOP
BRACKET
LAG
SCREWS
Position the top bracket so that it is
level and centered. Drill 1/8” pilot
holes and secure with lag screws.
CARRIAGE
BOLTS