Maximum Mini-Max - Manual

MINI-MAX
INSTALLATION
PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN
OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE
FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INSTALLATION.
30 Samuel Barnett Boulevard
New Bedford, MA 02745
(508) 995-2200
Form a drip loop with the wire at least eight inches
below the exit from the sensor and at least eight inches
below the point of entry into the building. Anchor any
exposed wire with insulated cable clips. Run the wire
through the building to the location where the indicator
will be located. Caulk any holes when done.
Mount the Brass Readout directly over the Feed-Thru-Hole
to avoid crimping the wire under the lip. We recommend
mounting the Readout on one of our pre-drilled and
centered panels.
Unplug the AC adaptor and disconnect the wires. Mystic is now ready for the final installation.
The adjustment that you have made will always remain intact.
Mount the temperature sensor assembly with the two
large wood screws. Select a location that is protected
from direct sunlight and sheltered. (A north exposure, six
feet above the ground will give the best results.)
1
2
3
4
5
DRIP
LOOP
WOOD
SCREWS
CAULK
CABLE
CLIP
8"
MIN
GREEN
GROUNDING
CORD
GREEN
GROUNDING
CORD
TO
TEMPERATURE
SENSOR
AC
ADAPTOR
CABLE-HOLE
WALL
SCREW
SCREW
LUG
SCREW
PRE-DRILLED PANEL
To prevent static from causing bad readings it is necessary to
"EARTH GROUND" you Mini-Max. Proceed as follows:
-Turn off the circuit-breaker to the outlet where the ground cord
is attached.
-Remove the outlet cover screw.
-Insert the outlet cover screw through the lug on the green
grounding cord and reinsert the outlet cover screw.
-Turn on the circuit-breaker to the outlet.
-Plug in the AC Adaptor.
-Reset the memories as described in the operating instructions
(next page).
Feed the AC Adaptor Cord, Green Grounding Cord and Sensor
wire to the Indicator. Connect the two temperature sensor wires
to the appropriate terminals (HEX NUTS) as shown in the
illustration. The polarity does not matter. Connect the AC adaptor
wires to their appropriate terminals (HEX NUTS) as shown in the
illustration. The polarity does not matter for these.