Maximum Chimney Mount User Manual
Chimney mount, Installation
CHIMNEY MOUNT
INSTALLATION
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Page 1
PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR,
ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY,
OR HARDWARE STORE FOR REFERRALS).
Slip the swaged end of mast A into the
round end of mast B.
1
2
WOOD BLOCK
SWAGED END
Tap the two sections together with a hammer.
A piece of wood will protect the end from
damage.
STAINLESS STEEL
STRAP
STRAP CLIPS
U-CLAMP
U-CLAMP
CHIMNEY
BRACKET
CHIMNEY
BRACKET
STRAP
BOLT
MAST B
STRAP
BOLT
SWAGED
END
3
MAST A
MAST B
MAST A
Insert all four strap bolts into chimney bracket holes,
securing approximately 1/4" thru external lock
washers into nuts. *Do not tighten any further
at this time*.
CHIMNEY
BRACKET
STRAP
BOLT
LOCK
WASHER
& NUT
LOCK
WASHER
& NUT
4a
Feed the strap through a strap clip as shown and
up through the strap bolt.
STRAP
CLIP
STRAP
BOLT
CHIMNEY
BRACKET
STRAP
Bend the strap and insert it back through the strap
clip.
4b
STAINLESS STEEL
STRAP
7/16”
TOOLS
REQUIRED
VISE GRIPS
HAMMER
TIN
SNIPS
TAPE MEASURE
7/16” WRENCH