Maximum Merlin User Manual
Merlin, Installation, 4a 4 3
MERLIN
INSTALLATION
PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN
OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE
FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INSTALLATION.
When connecting the wind direction sensor
to the Z-mast, make certain that terminal #4
is aligned with the Z-mast arm. If the sensor
is not installed in this manner your wind
direction readings will be incorrect.
Slide the stub masts through the rubber boots and
insert the stub masts into the bottom of the sensors. Secure
with the cotter pins. Coat all wire connections with silicone
sealant and slip the boots over the sensors.
2
1
5
TERMINAL #4
MUST ALIGN
WITH Z-MAST
ARM
TERMINAL
#4
WIND DIRECTION
SENSOR
BOSS
WIND DIRECTION
SENSOR
COTTER
PIN
COTTER
PIN
STRAIGHT
STUB MAST
Z-STUB
MAST
BLACK &
WHITE WIRE
GREEN &
RED WIRE
BOOT
4
WIND SPEED
SENSOR
F
reen wires through the other
eed the terminal lug end of the red and g
rubber boot. Connect the red wire to the terminal marked #4.
Connect the green wire to the terminal marked #5. The polarity MUST be
observed. Use the hex nuts provided. (Do NOT adjust the nuts that are
already on the wind direction sensor).
4
5
Feed the teminal lug end of the black and white wires through
one of the rubber boots and connect the lugs to the terminals on the
bottom of the wind speed sensor using the brass nuts provided. The polarity
does not matter.
T adjust the nuts that are already on the sensor).
(Do NO
Determine where you are going to locate both the
rooftop sensors and the read-out.
4A
4
3
BLACK AND WHITE
WIRES
BOOT
BOOT
RED
WIRE
GREEN
WIRE
Secure the sensors and stub masts to your antenna mast (not supplied) with
the two hose clamps. Align the wind-direction Z-mast arm to true North.
Radio Shack and similar stores have a selection of tall masts and roof
mounting brackets. Choose a mount that best suits your location and
provides at least eight feet of vertical clearance above objects on the roof.
HOSE
CLAMPS
TALL
MAST
NORTH
Page 1
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200