beautypg.com

Maximum Maestro 2S User Manual

Maestro 2-s, Installation, 4a 4 3

background image

MAESTRO 2-S

INSTALLATION

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE,

CONSULT A CONTRACTOR, ELECTRICIAN

OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE

FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INSTALLATION.

When assembling the wind direction sensor

to the Z-mast, make certain that terminal #3

is aligned with the Z-mast arm.

Slide the stub masts through the rubber boots and
insert the stub masts into the bottom of the sensors. Secure
with the cotter pins. Coat all wire connections with silicone
sealant and slip the boots over the sensors.

2

1

5

TERMINAL #3

MUST ALIGN

WITH Z-MAST

ARM

TERMINAL

#3

WIND DIRECTION

SENSOR

BOSS

WIND DIRECTION

SENSOR

COTTER

PIN

COTTER

PIN

STRAIGHT

STUB MAST

Z-STUB

MAST

5-CONDUCTOR

CABLE

2-CONDUCTOR

CABLE

BOOT

WIND SPEED

SENSOR

Feed the terminal lug end of the five-conductor
cable through the other rubber boot and connect
the lugs to the terminals on the bottom of the wind-direction
sensor. (Do NOT adjust the nuts that are already on the sensor).
The red sleeve indicates wire #1.

Feed the teminal lug end of the 2-conductor cable through one
of the rubber boots and connect the lugs to the terminals on the
bottom of the wind speed sensor. (Do NOT adjust the nuts
that are already on the sensor). The polarity does not matter.

Determine where you are going to locate both the
rooftop sensors and the read-out.

4A

4

3

Samuel Barnett Boulevard

New Bedford, MA 02745

(508) 995-2200

2-CONDUCTOR

CABLE

BOOT

BOSS

T-4

(S & SW)

T-2

(E & SE)

T-3

(POWER)

T-5

(W & NW)

1

3

4

5 2

TERMINAL-1

(N & NE)

RED

SLEEVE

5-CONDUCTOR

CABLE

BOOT

Secure the sensors and stub masts to your antenna mast (not supplied) with
the two hose clamps. Align the wind-direction Z-mast arm to true North.
Radio Shack and similar stores have a selection of tall masts and roof
mounting brackets. Choose a mount that best suits your location and
provides at least eight feet of vertical clearance above objects on the roof.

HOSE

CLAMPS

NORTH