Maximum Wireless Mystic - Manual (Page 3)

MYSTIC
INSTALLATION
WIRELESS
30 Barnet Boulevard
New Bedford, MA 02745
(508) 995-2200
Page 3
7
Once the transmitter has been activated, the default 32.0
temperature reading should be replaced by a present temperature
reading. Refer to the troubleshooting section if a present
temperature reading does not appear.
8
Replace the plastic battery cover. Make
sure to seat the cover properly over the
glued in gasket.
COVER
A KA INE L L
A I E AL K LN
TEMPERATURE
SENSOR
RECEIVER
9
TRANSMITTER
Move the active temperature transmitter as close as possible to
your preferred final mounting location. Also move the MYSTIC
indicator and receiver combination as close as possible to their
final mounting location. Select a location for the transmitter that
is protected from direct sunlight and sheltered from rain or
physical damage. A North exposure, six feet above the ground
will give the best results. Check to make sure that proper
communication between the transmitter and receiver still exists
by verifying that the light on the receiver is still flashing GREEN
every four seconds. NOTE: If more than 15 minutes has passed
since the test button on the temperature transmitter was pushed,
it will need to be pushed again. If the signal has been lost, move
the transmitter to an alternate mounting location and re-check
for proper communication.
GREEN