Campbell Scientific LoggerLink Mobile App for iOS - Manual (Page 9)

Neighbor
The PakBus address of the neighbor you will go through to
connect to your datalogger. A value of 0 means you will
connect directly to your datalogger.
Security Code
The Security Code is only required if security has been
enabled on your datalogger. In order for LoggerLink to
connect to a security-enabled datalogger, the security code
of at least level 3 is required. The level 3 security code
allows you to check the clock and collect data. The level 2
security code is required to set the clock or change public
variables. The level 1 security code unlocks the highest
level of security and allows you to change or retrieve the
program as well as change status table variables.
TCP Password
If you are trying to connect to a datalogger with a TCP
Password enabled, you must enter the password in order for
any communications to occur with the datalogger.
Encryption Key
This setting specifies text that will be used to generate the
key for encrypting PakBus messages sent or received by this
datalogger. The key entered here must match the PakBus
Encryption Key setting in the device.
Connecting
To connect to a datalogger, simply tap on the datalogger in your
list of dataloggers or tap the Connect button while viewing the
TOC 7