Campbell Scientific LoggerLink Mobile App for iOS - Manual (Page 31)

On Power-up will set this program file to run when the
datalogger loses power and then powers back up.
Settings
The Settings page is used to view and/or change the internal
settings of the datalogger. If needed, each setting has detailed
help available by tapping the "i" button next to the setting.
Tapping a writable value will allow you to change the value.
Once changes have been made to any setting(s), they must be
applied to the datalogger. Applying changes stores them to the
datalogger. Any setting that has been changed but not applied
will have an asterisk next to the setting name.
The following options are available by tapping the action button
in the upper right corner while in the Settings page.
Factory Defaults
When the Factory Defaults option is selected, the datalogger
settings will all be set back to their factory default values.
Refresh
When the Refresh option is selected, the datalogger settings
will be retrieved from the datalogger. (This option is only
available if there are no pending setting changes.)
Apply Changes
If changes have been made to any settings, the Apply
Changes option will be available. The changes are not
stored to the datalogger, until the Apply Changes option is
selected.
TOC 29