Campbell Scientific 9522B Iridium Satellite Modem and COM9522B Interface Modem - Manual (Page 14)

9522B Iridium Satellite Modem and COM9522B Interface Modem
11 Thornhill Dr., Suite 201
Dartmouth, NS, CANADA, B3B 1R9
T: (902) 405-4428
www.joubeh.com
If you have acquired a SIM card that needs to be unlocked, please see
Appendix C. This should be done before going to the field.
3.2 Setup of Iridium Modems
Once the SIM cards are unlocked (Appendix C), it is necessary to set up the
base and remote modems using Device Configuration Utility (DevConfig).
(The base and remote modems can also be set up using a terminal emulation
program such as Procomm or HyperTerminal.)
3.2.1 Step 1: Hardware Connections
Connect the Iridium satellite modem to the COM9522B and connect a serial
cable from the COM9522B to a COM Port on your computer. Connect the
COM9522B to the power supply. Be sure to connect the yellow power control
wire to +12V, so that the COM9522B will switch on power for the 9522B.
3.2.2 Step 2: DevConfig Connection
Open DevConfig. Under Device Type, select Unknown. Select the
appropriate Communication Port and set the Baud Rate to 19200. Press
Connect.
FIGURE 3-1. Starting a DevConfig Session
6