MagTek IntelliStripe 320 99875168 User Manual
Intellistripe 320, Command reference manual
Table of contents
Document Outline
- TABLE OF CONTENTS
- SECTION 1. APPLICATION MESSAGES
- SECTION 2. GENERIC COMMANDS
- SECTION 3. DEVICE APPLICATION
- SECTION 4. MAGNETIC STRIPE APPLICATION
- SECTION 5. SMART CARD APPLICATION
- GET/SET/SAVE PROPERTY COMMANDS
- RESPONSE CODES USED THROUGHOUT THE APPLICATION
- NOTIFICATIONS IN THE SMART CARD APPLICATION
- THE CONDRPT PROPERTY
- ERROR/WARNING CONDITION TEMPLATES
- CARD TYPES
- PROPERTIES
- ATR MAP STRUCTURE – MICROPROCESSOR CARDS ONLY
- POWER UP COMMAND
- POWER DOWN COMMAND
- T=0 ERROR / WARNING CONDITION TEMPLATES
- T=1 ERROR / WARNING CONDITION TEMPLATES
- WARM RESET COMMAND
- TPDU, CARD TO IFD COMMAND
- TPDU, IFD TO CARD COMMAND
- APDU EXCHANGE COMMAND
- SELECT CONNECTOR COMMAND
- SECTION 6. LED APPLICATION
- SECTION 7. TRANSPORT APPLICATION
- SECTION 8. BUZZER APPLICATION
- SECTION 9. HOST COMMUNICATIONS APPLICATION
- SECTION 10. OTI SCI 1000 CONTACTLESS SMART CARD APPLICATION
- APPENDIX A. EXAMPLE HOST APPLICATION
- APPENDIX B. MEMORY CARD SUPPORT
- APPENDIX C. MIFARE COMMANDS
- INDEX