MagTek IntelliStripe 320 99875168 - Manual (Page 69)

Section 7. Transport Application
63
POWER FAIL DETECT PROPERTY
Property ID: ff (Hex)
Property Type: Boolean
Power Up/Reset Value: 1 (Enabled)
Get/Set/Save support: All
Description:
This property is used to enable and disable power fail detection. When power fail detection is
enabled, the device will monitor its supply voltage. If the supply voltage falls significantly out
of the specified range, the device will eject any cards that are present, provided a power fail eject
capacitor is connected to the device, then it will wait for the supply voltage to return to normal
after which it will perform a power up reset cycle.
Values:
Value State Description
0 Disabled Power fail detect disabled.
1 Enabled Power fail detect enabled.
Example Set Property Request:
Field MTYP APPL CMND RC PTYP PID
Byte 1 2 3 4 5 6
Value (Hex) 00 82 01 00 03 ff
Field PVAL
Byte 7
Value (Hex)
01 (Enabled)
Example Set Property Response:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 40 82 01 00