MagTek IntelliStripe 320 99875168 - Manual (Page 66)

IntelliStripe 320 Command Reference
60
AUTO CONSUME PROPERTY
Property ID: 03 (Hex)
Property Type: Boolean
Power Up/Reset Value: 0 (Disabled)
Get/Set/Save support: All
Description:
This property is used to enable and disable card auto consuming. When auto consuming is
enabled, the reader will attempt to consume a card when the card is being inserted into the mouth
of the reader. The transport attempts to consume a card into the transport to a position where
smart card communications can occur and magnetic stripe reading is complete. The reader will
not attempt to consume a card if a card is already present in the transport. When the reader is
attempting to automatically consume a card, the Auto Transporting indicator is set. If the
consume attempt is successful and the card is standard size, the Rear Card Present indicator and
the Middle Card Present indicator will be set to show that the card is completely consumed. If
the Middle Card Present indicator is set and the consume attempt is unsuccessful, then the card
should be ejected. After a card is ejected or a consume fails, the card needs to be completely
removed from the reader before the reader attempts to automatically consume a card again.
Values:
Value State Description
0 Disabled Cards will not be automatically consumed.
1 Enabled Cards will be automatically consumed.
Example Set Property Request:
Field MTYP APPL CMND RC PTYP PID PVAL
Byte 1 2 3 4 5 6 7
Value (Hex) 00 82 01 00 03 03 01 (Enabled)
Example Set Property Response:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 40 82 01 00