MagTek MICRSafe99875466 - Manual (Page 10)

MICRSafe with 3-Track MSR
2
FEATURES
•
This device incorporates a MICR Reader with a 3-Track MagneSafe MSR.
•
The three track MSR autodiscriminates different card formats: ISO (International Standards
Organization), CDL (California Drivers License), or AAMVA (American Association of
Motor Vehicle Administrators).
•
Small footprint.
•
Automatic parsing of MICR fields: transit, account, etc.
•
Extensive list of formats to transmit MICR data.
•
Optional error/status reporting for check reading.
•
Optional TDES DUKPT encryption of MICR and Card data.
•
Reads E13-B and CMC-7 MICR fonts.
•
Automatically goes into sleep mode when not in use; meets EnergyStar requirements.
•
EMF noise detection
•
Compatible with USB specification Revisions 2.0 and 1.1
•
Compatible with HID specification Versions 2.0 and 1.1
•
USB communications with the host may occur via a Virtual COM port or by HID/keyboard
emulation.
•
Communications with third party systems may occur via an auxiliary RS-232 interface or
using standard Windows HID drivers. No third party device driver is required.
ACCESSORIES
Accessories available for the MICRSafe are as follows:
•
Standard USB cable, Part Number 22553301
•
Optional auxiliary RS-232 cable, Part Number 22517584 /22517509
•
DC Power Adapter with Cable, 120VAC to 12 VDC, 1 Amp, Part Number 64300118
(64300121 for international customers)
•
MICR Reader Cleaning Card, Part Number 96700006
•
Sample Checks, Part Number 96530005
•
MICRbase Setup Program, Part Number 22000021
SOFTWARE DRIVERS REQUIRED
If you are using the HID unit, the standard HID and Keyboard drivers that come with an
operating system are usually all that is needed. For example, the Windows operating system
provides all the drivers needed to communicate to the device, unless you requested that the
factory configure your MICRSafe device(s) to use a VCOM port. In that case, you would need to
download the VCOM driver from the MagTek website. This driver allows a USB device such as
the MICRSafe to appear as an additional COM port available to the PC, enabling application
software to access the USB device as if it were connected via a standard COM (RS-232) port.