Videotec MAXIMUS WASEX - Manual (Page 6)

EN - English - I
nstruc
tions manual
4
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
No special requirements are demanded
from those in charge of handling; therefore
follow normal accident prevention
regulations when carrying out this
operation.
5.1 Safety precautions before use
Never exceed performance specifications.
Make all connections in a non-explosive
atmosphere.
Before starting any operation, make sure
the power supply is disconnected.
The electrical system to which the unit is
connected must be equipped with a bipolar
circuit breaker. The minimum distance
between the contacts must be 3mm (0.1in).
The circuit breaker must be provided
with protection against the fault current
towards the ground (differential) and the
overcurrent (magnetothermal, maximum
15A).
The assembly and installation must be
performed only by skilled personnel.
Make connections and tests in the
laboratory before carrying out installation
on site. Use appropriate tools for the
purpose.
5.2 Unpacking and contents
5.2.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Unscrew the 2 side screws to open the
cover.
Fig. 5
5.2.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Washer kit
• Washer pipe support
• Locking bracket for pipe support
• Screws and washers
• Washer pipe (with nozzle)
• Pipe connector
• Stainless steel clamps
• Delivery pipe
• Sealing rings
• Instructions manual
• Solenoid valve user and installation manual