Dake Model LE10A - Manual (Page 9)

12/10/07 Model LE10A Text 9
Figure 3.4
Warning!!!!
Failure to remove this bracket could cause damage to the machine and void the
warranty.
INITIAL OILING: Clean the machine thoroughly. Be sure anti-corrosion additives
applied to sliding parts are removed with cleaning oil. When making a test run refer
to the instructions on 8-1 for proper oiling.
Be sure the cutting fluid is full before operating, since it is usually drained before
packing. Use the oil gauge to check oil and cutting fluid level in the machine.
Warning!!!!!
Do not start the motor without oil; damage to the pump will result .
WARNING!!!!
Only a licensed electrician who follows local and state laws is authorized to
connect power to this machine.
The power supply cord will need to come out of the electric box located on the left
side of the machine. Connect power source to the terminals on this cord. Once
connected, turn the main power on (on the left side of machine). The green lamp
should now be on.
Attach grounding terminal located beside the power cord to the factory ground line.
This red bracket
must be removed
before the
electrical is
connected.
OIL FILL
OIL GAUGE