Dake Model LE10A - Manual (Page 4)

12/10/07 Model LE10A Text 4
2.1 General Product Specifications
Machine Type Horizontal scissors type
Rapid Head
Approach
Sure stop hydraulically
controlled
Capacity
Bundled
4-½ “ – 7” wide, 5-½ “ high Blade Tensioning
Mechanical with preset locking
ring
Drop Length
Possible
Less than 2 inches Electrical
CE approved / Thermo
overload, low voltage
protection, 110 control voltage
Blade Size 138 inches x 1 inch System Control PLC
Blade Speeds
88 / 130 / 177 / 223 / 262
F.P.M.
Warning Light Yes
Feed Stroke
(Single)
3/8 inch minimum - 16 inch
maximum
Auto Shut Off
Pieces reached, out of stock,
blade slippage/breakage
Multiple
Stroke
9 times (142 inches maximum) Chip Brush Speed synchronized
Feed Type
Hydraulic hitch feed with vertical
rollers, feed speed 16 inches in
6 seconds
Foot Print
76 inches x 69 inches (145
inches deep without roller
support)
Length Set Up
Front mounted hand wheel, and
DRO with large numeral digits.
Roller Support w/
vertical roller
dimensions
72 inches long x 16 inches wide
Horse Power
Blade Motor
3 H.P. Work Height 21-½ inches
Hydraulic
Pump HP
1 H.P. Weight 2700 pounds
Coolant Pump
Type & HP
Gear type 1/8 H.P. Tool Kit
Standard – Includes screw
drivers, wrenches and Allan
keys
Hydraulic Oil
Capacity
1.2 gallons Spare Parts
Standard – Includes chip
brushes and guide bearing
replacements
Coolant
Capacity
10 gallons Work Light Standard
Vises (Quick
set ratchet
type)
Hydraulic with blade forward
clamping for minimized burr and
with 1” throw
Machine Support
Pads
Standard
Vise
Clamping
Pressure
600 pounds
Collective Hour
Timer
Standard
Vise Ways Precision ground and hardened
Auger Style Chip
Removal System
Standard
Work Table
Machined with chip clearance
inserts
Guarding Full hinged
Hitch Feed
Capacity
2790 pounds with use of roller
table
Lubricant
Flood type unit built into the
machine (Electric)
Hydraulic
Pump
Hydraulics on demand (HOD)
with minimum pressure start up
Voltage
• Available 230-volt three phase
• Available 460-volt three phase
(external transformer)
Machine should be wired to
main service by a qualified
Electrician.
Head Feed
Hydraulic regulation with RPM
compensation feed back
AMP
• 20-amp service for 230-volt
machine
• 16-amp service for 460-volt
machine
Piece Counter 9,999 piece with auto shut off
Operating
Temperature
No special operating
temperature level