Dake Model LE10A - Manual (Page 17)

12/10/07 Model LE10A Text 17
4.5 Automatic operation instructions
AUTOMATIC OPERATION
1. Cut the edge of the work piece by using the same procedures as those
described under the Manual Operation Section above.
2. Press the raise button to raise the saw blade until the quick approach feeler is
approximately 10mm (0.4 in) above the work piece.
3. Turn the vise clamp selector to open the front vise.
4. Press the rear vise forward button until the work piece moves forward to the
required cutting position.
5. Turn the vise clamp selector to clamp the work piece with the front vise.
6. Press the rear vise forward button until the rear vise moves to the forward
position.
4.6 Part length set up
How to set the required cutting length on the cutting length counter .
WARNING!!!!!
Do not change the numerals (number of feeds) on the feeding times
preset counter during operation.
a. Loosen the hand-wheel lock screw.
b. Turn the hand-wheel to set the required cutting length on the cutting
length counter.
NOTE :
1. When setting the cutting length, be sure to turn the hand wheel
clockwise past the desired length, then turn it counter clock wise to
the desired length to prevent error due to the backlash.
c. Tighten the hand-wheel lock screw
7. If the required cutting length exceeds the maximum cutting length of 23.6 inches
(600mm), feed the work piece as many times as necessary, using the feed
times preset counter (item 14 page 11). For example: if a cutting length of 31.5
inches (800mm) is required.
a. Divide 31.5 by 2 =15.75
b. This will be the length of cut needed to make 31.5 inches.