Dake Model LE10A - Manual (Page 18)

12/10/07 Model LE10A Text 18
c. Set the feed times counter at 2.
d. Now the material will be pushed forward two times, each time moving
the material forward 15.75 inches.
NOTE:
1. The cutting length preset device is factory adjusted to
compensate for the set width of the saw blade.
2. When the feeding times preset counter is not in use, set it a
1.
3. The feeding times preset counter is capable of feeding the
work piece nine times, up to a maximum cutting length of
212.5 inches (5400mm).
8. How to set the number of required cuts on the cutting piece counter .
Warning!!!!!
Do not change the number of cuts during cutting operation.
a. Set the cutting piece counter switch (item 12 page 11) at “o” (OFF).
b. Press the reset button (on the bottom of the readout) to reset all white
numerals to zero.
c. On the top of this read out there are five black buttons, each button is
a different digit. Push these buttons to desired amount of pieces to be
cut.
d. After the number of cuts has been set.
e. Set the counter ON/OFF switch at “| “(ON).
9. Turn the auto-manual selector to AUTO and press the blade drive button. The
blade will run and the automatic operation will begin.
10. After the required number of cuts have been completed, the saw blade will stop
in the lower position and all machine operations will stop.
NOTE:
1. During automatic operation, shifting the auto-manual selector
to MANUAL will cause the saw blade to stop in the lower
position, after completion of the cutting operation on which
the selector was shifted.
4.7 How to install bundle attachments
How to use the bundle cutting attachments
WARINING!!!!!
Never install the bundle attachments while the machine is in
operation. This machine electricity must be locked out before
installing bundle attachments.