Dake Model LE10A User Manual
Page 19
12/10/07 Model LE10A Text
19
WARNING!!!!!
Keep fingers clear of vise, personal injury could occur.
This multi-vise is used when bundle cutting is performed. To perform bundle cutting,
proceed as follows:
1. Install the stud bolts on the front and rear vises and position the multi-vise on
the front and rear vises.
2. Connect the multi-vise hoses to their quick connectors at the front and rear vise
cylinders.
3. Attach the bundle cutting fence to the work tray. The fence is designed to
prevent the cut pieces from spreading out across the work tray. Adjust the width
of the fence so that it equals the width of the bundle.
4. Set the switch to bundle cutting (item 13 pages 11).
5. Position the work piece for bundle cutting.
Allowable clamping width: 7 inches (180mm)
6. Roughly align the center of the multi-vise cylinders with the center of the work
pieces to be cut and tighten the lock nuts.
7. Turn the multi-vise handles so that there is 1/4” of clearance between the work
retaining plate and the material.
8. For subsequent operations, refer to the instructions for manual operation and
automatic operation, and perform the bundle cutting.
EXAMPLE:
CORRECT
INCORRECT