Dake Model LE10A User Manual
Page 13
12/10/07 Model LE10A Text
13
For bundle cutting, set this switch to the multiple picture, so that the rear vise
remains at the forward limit position. For single cutting, set this switch to the single
picture, so that the rear vise stays at the backward limit position.
NOTE: When the switch is set for bundle cutting, the blade will not start
unless the rear vise is at the forward limit position.
14. FEEDING-TIMES PRESET COUNTER
When a cutting length of more than 23” (600mm) is required, preset the required
number of feeds on this counter. The counter is capable of being set to the
maximum of nine feeds. 9*15.74=141.66 (9 x 400mm = 3600mm)
15. WORKING LIGHT
Turn this knob to the left to have the work light on, turn the knob to the right to have
the work light off.
16. BLADE SPEED ADJUSTING BUTTON (Not Shown)
The saw blade speed suited for the work piece to be cut can easily be founded by
depressing these buttons. Use the speed indication as a guide for selecting the saw
blade speed.
12. CUTTING PRESSURE CONTROL & FLOW CONTROL (Not Shown used on
LE13A only))
When this control is turned clockwise, the cutting force of the saw blade increases;
when it is turned counterclockwise, the cutting force decreases. Align the pressure
control with the zone which corresponds to the material on the work piece to be cut.
4.2 Blade change
1. Select the saw blade best suited for the work piece to be cut. Size and
shape of the work piece and type of material should all be considered when
selecting the saw blade to be used.
2.
Saw blade change
.
Warning!!!!!
Always wear gloves, safety glasses and other protective equipment
to prevent injury when changing the saw blade. The power must be
locked out before changing the saw blade.
a. Turn on the main power on the left side of the machine.
b. Press the hydraulic ON button to start the hydraulic pump motor.(item
6 page 11)
c. Turn the auto-manual selector to manual position (the hand item 4
page 11)
d. Press the raise button (item 6 pages 11) to raise the saw head until it
is above the vise.
e. Push the emergency stop button and turn off the main power on the
machine.