DME Auto-Fixed Integral Heater Micro - Manual

DANGER
WARNING
out residual moisture before applying full power. Failure to do so may cause
IMPORTANT SAFETY INFORMATION
A hot-runner system includes electrical elements and may contain molten
plastic at elevated temperature and pressure. To avoid injury, exercise
caution by reading these instructions before servicing or operating the
system.
These instructions must be passed on to the end user where they should
be read before using this product. Failure to do so can result in serious
injury or death.
Failure to comply can result in serious injury or death:
STORED ENERGY AND HIGH TEMPERATURE HAZARDS
This product maintains molten plastic at high pressure. Use caution when
operating and servicing the system.
Physical contact with molten plastic may result in severe burns. Proper
protective equipment, including eye protection, must be worn. This product
has heated surfaces. Use caution when operating and servicing the system
to avoid severe burns. Proper protective equipment should be worn.
Failure to comply will result in serious injury or death:
ELECTRICAL HAZARDS
Improper voltages or grounding can result in electrical shock. Use only
with proper voltage and a proper earth ground.
To avoid electrical shock, do not operate product when wet.
Do not operate this equipment with covers or panels removed.
To avoid electrical shock, turn off main power disconnect and lockout /
tag out before servicing this device. Do not connect temperature sensors to
electrical power. It will damage the product and it can cause fire, severe
injuries or even death.
If green ground wire present wire must be connected to the ground.
Do not rebend rigid leads. Rebending leads might result in damage to circuit.
Product might absorb moisture when cool. Use low Voltage or power to drive
damage to this product.
0.620 DIA.
B
0.312 -0.001
0.000
DIA.
0.394 -0.001
0.000
DIA.
0.625
0.375
4
5
°
A
0.157
0.005 DIA.
20°
0.125 R.
0.030 R.
0.062
(GRIND TO SUIT) I.D.
ADJUSTMENT RINGS
(Packaged with all probes)
Note: Dimensions shown in Inches.
AFIP3-410-90 4.095
AFIP3-310-90
RAF3-062
REGISTER RING
Please read carefully before installing probes
MICRO PROBES
This procedure discolors the outer surface of the probe,
Each Integral Heater probe sold by D-M-E is pretested.
AUTO-FIXED INTEGRAL HEATER
WATTS
REFER TO : MINI PRINT # 1700
but in no way alters its performance or dimensions
MATERIAL, AISI D-2 STEEL OR EQUIVALENT HARDNESS, 50-55 RC
(240 VAC, T/C TYPE J, 48" LEADS)
(Installed in probe)
THERMOCOUPLE
AUTO-FIXED " INTEGRAL HEATER" MICRO PROBES
NOTE: PROBE DISCOLORATION
ME-0725-PS-216-B AFIP/ID
3.095 2.720 110
09-08
3.595
AFGI-03N
170 4.220 4.595 AFIP3-460-90
3.220 130
AFRR-03N
GATE INSERT
48" TC-9900
LEAD LENGTH CATALOG NUMBER
0.456 RAF3-062
I.D. CATALOG NUMBER
150 3.720
ADJUSTMENT RING
TC-9900 THERMOCOUPLE
AFIP3-310-90 THRU AFIP3-460-90
USED WITH
ITEM
AFIP3-360-90
CATALOG NUMBER A DIM. B DIM.